Skip to main content
Cherry & DennisHELPER HABITAT

Cherry & Dennis

What are you looking for?

Enter a keyword to search the website.

breast-pump parts prepared safely after its specific cleaning workflow

Families with children

How to Clean Removable Breast-pump Parts by Maker Instructions

Take apart only the removable milk-contact parts, rinse, wash in warm water, rinse again, and air-dry on a clean surface; sanitising follows only the maker or health authority.

Read the full guide
Time
10–20 minutes active work, plus complete drying
Difficulty
Medium
Recommended frequency
Arrange by use, visible soil and manufacturer instructions
Risk
High
Reference number
HW187

Overview

Take apart only the removable milk-contact parts, rinse, wash in warm water, rinse again, and air-dry on a clean surface; sanitising follows only the maker or health authority.

Tools needed

  • pump manual
  • clean wash basin
  • mild dish soap
  • dedicated brush
  • clean air-drying rack

Cleaning steps

Step 1

Disassemble milk parts

Wash hands and take apart only the removable milk-contact parts named in the pump manual; keep motor, tubing and electrical parts dry unless the manual says otherwise.

Step 2

Rinse before washing

Rinse milk-contact parts under running water soon after use, without scraping them with sharp tools.

Step 3

Wash, rinse and air-dry

Wash each part in a dedicated basin with warm water and mild soap, rinse thoroughly, and air-dry on a clean unused towel or clean rack; do not towel-rub the inside.

Step 4

Sanitise only if directed

If sanitising is needed, do it only after washing and by the pump maker or relevant health guidance; reassemble only when fully dry.

Common mistakes

Putting the motor or power unit in wash water — Keep the motor, power unit and manual-designated dry parts out of the wash basin.
✕ Avoid

Putting the motor or power unit in wash water

✓ Correct action

Keep the motor, power unit and manual-designated dry parts out of the wash basin.

Rinsing milk parts but not washing them — After the initial rinse, wash every removable milk-contact part in warm soapy water.
✕ Avoid

Rinsing milk parts but not washing them

✓ Correct action

After the initial rinse, wash every removable milk-contact part in warm soapy water.

Towel-drying the inside of washed parts — Place rinsed parts on a clean unused rack or towel to air-dry instead of wiping the inside.
✕ Avoid

Towel-drying the inside of washed parts

✓ Correct action

Place rinsed parts on a clean unused rack or towel to air-dry instead of wiping the inside.

Treating washing as sanitising — Complete any sanitising only after washing and only by the exact pump instructions.
✕ Avoid

Treating washing as sanitising

✓ Correct action

Complete any sanitising only after washing and only by the exact pump instructions.

Practical tips

Tips for helpers

  • Lay parts in the manual’s order before washing so every valve, membrane and connector returns to the right place.
  • Keep the wash basin and brush for feeding equipment only.

Tips for employers

  • Keep the exact pump manual and approved replacement valves, membranes and brushes together.
  • Confirm the household’s current sanitising instruction separately from routine washing.

Completion checklist

Checked 0 / 4

Ticks are saved on this device. Reset before starting a new task.

Share this guide

Share language
Share on WhatsApp
How to Clean Removable Breast-pump Parts by Maker Instructions

Before you begin: safety guidance

  • Do not immerse the motor, power unit or any part the manual says to keep dry.
  • Cleaning is not sterilising; never invent a sanitising time, temperature or chemical concentration.

Enlarge image