Home cleaning
How to Clean Window Glass Safely
Clean only safely reachable interior areas and apply Hong Kong safety rules before any exterior-window work
Overview
First confirm the glass can be reached safely from indoors while standing on the floor. High-level exterior glass, leaning out and elevated access are outside this guide; stop and ask the employer to arrange a compliant method.
Tools needed
- Two clean microfibre cloths
- Window squeegee
- Small bucket or spray bottle
- Absorbent floor towel
- Cleaner permitted for the glass and product label
Cleaning steps
Confirm the safe scope
Clean only glass reachable from indoors while standing on the floor. Stop if the area requires leaning, a sill, chair or ladder.
Secure the window and floor
Close or secure movable panels as appropriate, keep children and pets away, remove trip hazards and place an absorbent towel below.
Remove dry dust first
Use a clean dry cloth from top to bottom to lift dust and loose grit before wet cleaning.
Prepare a small amount by label
Use a glass-suitable product exactly as labelled and never improvise cleaner mixtures.
Clean the interior glass
Apply a controlled amount to the cloth or reachable pane and wipe overlapping passes top to bottom, away from sockets and frame gaps.
Squeegee the moisture
Move top to bottom with slight overlap and wipe the rubber edge after every pass.
Dry and inspect
Dry edges, frame, sill and floor. Report cracked glass, loose parts or any exterior-window hazard to the employer.
Common mistakes
Reaching out for exterior glass
✓ Correct actionStay with safely reachable interior glass; refuse and report exterior work that does not meet the rules.
Standing on a chair or sill
✓ Correct actionKeep both feet on a dry floor and clean only the natural reach zone.
Wet wiping over loose grit
✓ Correct actionDry-remove loose particles before controlled damp cleaning.
Leaving drips and a wet floor
✓ Correct actionDry the frame and floor immediately and keep the area isolated until safe.
Practical tips
Tips for helpers
- Arrange tools within safe indoor reach without blocking the route.
- Dry each small section as it is completed so dirty water does not spread.
Tips for employers
- Provide manufacturer care information and suitable tools; do not assign elevated or unsafe exterior-window work.
- Identify damaged areas, electronics and special finishes that must be avoided.
Completion checklist
Checked 0 / 6
